Solartronics Sine Inverter 24V to 230V 300W 600W

These branch plugs are used to connect solar modules parallely to maintain a constant voltage. Ideal for 12V-systems or the connection of thin-film modules. Details: 1 Pair Y-connectors for a parallel connection of solar modules easy snap-in connection system for cables with a max. diameter of 4 - 6mm² ideal for 12V-systems and thin-film modules suitable for voltages up to max. 1000V DC snap-in connection system IP67 compatible with solar connector plugs Scope of Delivery: 1x Offgridtec branch plugs Y-Connectors (pair)

The Steca PR 1010 was designed for photovoltaic systems to charge 12V and 24V batteries. In contrary to the Steca PRS seriesthe PR series is equipped with a LCD display which makes it easy to control the device's funtions and shows all current working parameteres. Generally the controller is only usable with the following battery types:- lead-accumulators with liquid electrolytes- sealed lead-accumulators, AGM, gel- 12V and 24V consumers, which can be directly connected to the controller (right connection pair) Protection functions:- protection from reverse polarized modules- protection from reverse polarized consumers- protection from reverse polarized batteries- prevents from battery charge and discharge- short-circuit protection on module input- short-circuit protection on load output- protection from a too high charging current- no-load working test without battery or consumer- current reflow protection- over/undervoltage protection- overheating protection- deep discharge protection- CE-compliant

Offgridtec AGM solar batteries are explicitly designed for use in solar and hybrid systems. AGM technology is clearly superior to conventional lead-acid batteries with liquid electrolyte and offers the following advantages: Advantages of using Offgridtec AGM Technology absolutely safe from leakage, regardless of the position of the battery screw terminals instead of battery terminals (100% fixed) 100% maintenance-free over the entire service life Life expectancy up to 10 years (depending on usage pattern) Highest quality level: Our batteries are all A-quality and made of the best materials. This can best be seen in the weight of the batteries. Compare our products with those of other manufacturers! can be discharged deeper than lead-acid batteries mature technology, used in over 1000 Offgridtec solar systems very cycle-resistant, therefore predestined for use in solar systems AGM batteries are somewhat more expensive to purchase than lead-acid batteries, but this pays off after just a few years, as lead-acid systems require much more maintenance and have a shorter life than AGM-based storage solutions. Especially for smaller energy generation systems with a maximum storage capacity of 4-8kWh, AGM is the first choice. Technical data Battery type: AGM Cycle type Storage capacity 20HR(1.6A,1.75V): 32 Ah Storage capacity 10HR(3.0A,1.75V): 30Ah Storage capacity 5HR(5.2A,1.75V): 26Ah Storage capacity 1HR(19.5A,1.75V): 19,5Ah System voltage: 12V Charge voltage cyclic use: 14.4V-15V (-30mV/ °C) Charging voltage standby use: 13.6V-13.8V (-20mV/ °C) Max. charging current: 7.5A Self-discharge: 3% (per month) Battery terminal: Screw terminal with 5.5mm diameter Weight: 10 kg Dimensions: 195 x 130 x 159*mm (*+5mm terminal) Life expectancy: up to 10 years (depending on usage pattern) Battery regulation You are legally obliged to return batteries. You can return them after use to our sales outlet or to a local municipal collection point. Important information according to Battery regulation Ordinance on the return and disposal of used batteries. Batteries and rechargeable batteries do not belong in household waste. Consumers are legally obliged to return used batteries. They can be returned to Offgridtec.com or to public collection points in the community. Pursuant to § 10 of the Battery Act, a deposit of 7.50 Euro including VAT must be charged by the seller if the end consumer does not have a used starter battery on hand at the time of purchase. If the seller does not charge a deposit because the used battery has been disposed of properly or has been exchanged for new, this amount is not deductible from the purchase Price.

The Steca PR 3030 was designed for photovoltaic systems to charge 12V and 24V batteries. In contrary to the Steca PRS seriesthe PR series is equipped with a LCD display which makes it easy to control the device's funtions and shows all current working parameteres. Generally the controller is only usable with the following battery types: - lead-accumulators with liquid electrolytes- sealed lead-accumulators, AGM, gel- 12V and 24V consumers, which can be directly connected to the controller (right connection pair) Protection functions: - protection from reverse polarized modules- protection from reverse polarized consumers- protection from reverse polarized batteries- prevents from battery charge and discharge- short-circuit protection on module input- short-circuit protection on load output- protection from a to high charging current- no-load working test without battery or consumer- current reflow protection- over/undervoltage protection- overheating protection- deep discharge protection- CE-compliant

This double-core solar cable connects module and charge controller professionally. On the module-side this cable is equipped with original MC4-connectors and ferrules on the controller-side. Most 12V modules come with MC4-connectors. If your module is equipped with other connectors you find fitting adaptors in our shop. All components were crimped with professional tools and provide an excellent connection quality. Details: Length: 8m MC4-plugs 6mm² diameter double-isolated UV-, ozone-, weather- and water-resistant very flexible

This high-quality cable is needed to connect your charging regulator to an accumulator. The cable comes with a wire end sleeve for a connection to the charging regulator and M8 circular eyelets to connect to a battery. The binding posts are included in the scope of delivery. Features: 1,5m /2 x 6mm² battery cable with 20A fuse connects charging regulator and battery professional manufactured high-quality materials quick and easy installation Technical data:Cable diameter: 2 x 6mm²Fuse: 20ALength: 1,5m

6mm² solar cable from Helu-Kabel (made in Germany) with original MC4-plug - completely prefabricated. These cables are prepared with special tools and can be used instantly.Features: original MC4-plugs prefabricated with special tools plug & play made in Germany Technical data: cable diameter: 6mm² cable length: 50cm plugs: 2 x MC4-plugs (male / female)

100W / 12V solar panel with monocrystalline solar cells. Ideal for 12V-systems. Features: Monocrystalline solar cells 2 bypass-diodes: minimizes power degradation during shady periods Surface: hardened ESG-solarglass and weather resistant coating Frame: anodized aluminium Connection cable: 80cm; MC4 plug Ideal for 12V-systems Performance guarantee: < 10 years - 90%; <25 years 80% For the production of our modules we only use high-quality monocrystalline solar cells. The module frame made of anodized aluminium and a special ESG-solar glass make the module very resistant against abrasion.  

The solar module 50w mono from Offgridtec (mpn 3-01-001260) uses monocrystalline solar cells with a high efficiency of >22% and is ideal for 12v systems thanks to its 20v operating voltage. In Offgridtec mono solar modules only cells of the highest quality grade are installed and guarantee a constant high quality and performance with maximum service life thanks to state-of-the-art manufacturing. Features of Offgridtec 50w 12v mono solar panel Power (Pmax): 50w proven quality directly from Offgridtec high operating voltage of 20v, perfect for 12v systems manufactured according to the latest standards monocrystalline A-grade solar cells extremely resistant ESG glass makes the module usable even in the most adverse environmental conditions ideal for 12v systems on land or in mobile solar systems 1 bypass diode - minimized power loss in shaded conditions Proven, immediately operational solar module The mono 50w 20v is one of over 40 proven solar panels from the Offgridtec portfolio and participates in Offgridtecs experience in manufacturing high quality 12v and 24v solar cells. The module can be used in very adverse operating conditions thanks to the extremely resistant solar glass. It can withstand heavy hail and storms or extreme cold and heat without any problems and thanks to the monocrystalline A-grade cells you can count on noteworthy yields even on cloudy days. The most important technical data at a glance Working voltage (Vmp): 20 V Open circuit voltage (Voc): 24 V max. current (Imp): 2.5 A Short circuit current (Isc): 2.7 A max. system voltage: 1000 V permissible ambient temperature: -40°C - +85°C Dimensions: 520 x 550 x 25 mm Weight: 3,7 kg Part number: 3-01-001260 Universally applicable Offgridtecs 50w 20v Mono is universally applicable for example in 12 volt Solaranlagen on garden sheds, allotments or for the power supply of lighting applications, self-sufficient systems of signal and surveillance technology and many more. But also in mobile systems such as in mobile home solar systems this panel makes a good figure. Due to the integrated bypass diode, the module can continue to produce power even in shaded or dim light conditions.The connection cables are 80 cm long and equipped with MC4 connectors. Scope of delivery: Offgridtec 3-01-001260 50w mono 20v solar module

The solar module 130w mono from Offgridtec (mpn 3-01-001250) works with monocrystalline solar cells with a high efficiency of >18,5% and is ideal for 12v systems thanks to its 20v operating voltage. In Offgridtec mono solar modules only cells of the highest quality grade are installed and guarantee a constant high quality and performance with maximum service life thanks to state-of-the-art manufacturing. Features of Offgridtec 130w 12v mono solar panel proven quality directly from Offgridtec high operating voltage of 20v, perfect for 12v systems manufactured according to the latest standards monocrystalline solar cells extremely resistant ESG glass makes the module usable even in the most adverse environmental conditions ideal for 12v systems on land or in mobile solar systems 2 bypass diodes - minimized power loss in shaded conditions 3 busbars The mono 130w 12v is one of over 40 proven solar panels from the Offgridtec portfolio and participates in Offgridtecs experience in manufacturing high quality 12v and 24v solar cells. The module can be used in very adverse operating conditions thanks to the extremely resistant solar glass. It can withstand heavy hail and storms or extreme cold and heat without any problems and thanks to the integrated bypass diodes, the module can continue to produce power even in shaded or low light conditions. The most important technical data at a glance Power (Pmax): 130w Working voltage (Vmp): 20 V Open circuit voltage (Voc): 24 V max. current (Imp): 6.5 A Short circuit current (Isc): 7.02 A max. system voltage: 1000 V permissible ambient temperature: -40°C - +85°C Dimensions: 1020 x 680 x 35 mm Weight: 10 kg Universally applicable Offgridtecs 130w 12v Mono is universally applicable for example in 12 volt Solaranlagen on garden houses, allotments or for the power supply of lighting applications, self-sufficient systems of signal and surveillance technology and many more. But also in mobile systems such as in mobile home solar systems this panel makes a good figure. The connection cables are 80 cm long and equipped with MC4 connectors. Scope of delivery: Offgridtec 3-01-001250 130w mono 12v solar panel

You need this cable to connect your charge controller with a battery. The connection cable was manufactured under high quality standards in Germany. The delivery includes a fuse and a pair of battery terminals. The cable length is 1.5m. The cable can be connected to any charge controller with appropriate receptacle (min. 6mm²). The processed solar cable comes from the manufacturer Lapp-Kabel and is a top brand product.2 x 6mm² cableLength: 1,5mwith m6 ring cable lug on the battery sidecut at the other end of the cable for easy removal of the sheath and exposure of the bare wirewith integrated flat fuse holderwith fuse and battery terminalsprofessional manufacturinghigh quality materials