KEMO M176 Marten repellent for motor vehicles 12 V/DC, waterproof to IP 65*

Repel martens with high-voltage plates (movable) charged to approx. 200–300 V/DC, using electric shocks in the vehicle engine compartment (only weak currentsthat only scare away the martens and do not kill them) and strong, aggressively pulsating ultrasonic sounds. Extremely low power consumption (< 0.005 A), automatically switches off at battery voltage < 11.5 V/DC (does not drain the battery in cars that are parked for long periods). The basic device with ultrasonic sound emission is waterproof according to IP 65* and can be mounted directly at the marten's entry point in the car. Built-in, bright flashing LED.

Important features

• waterproof to IP65
• 3-fold effective: ultrasound, electric shock, pulsating light
• Soft start so that the on-board computer is not disturbed.
• Automatic shut-off to prevent the car battery from being completely discharged
• protected against voltage spikes in the vehicle electrical system up to 40V (< 20ms).

Technical data:

Features: - Waterproof | Triple action: ultrasound, electric shock, pulsating light.
Sealing: The control unit with the loudspeaker is waterproof according to IP 65* (can be mounted on the entry holes of the vehicle)
Operating voltage: 12 - 15 V/DC (car battery)
Current consumption: average < 5 mA
Switch-on function: Soft start so that the on-board computer is not disturbed.
Automatic switch-off: when the battery voltage drops below 11.5 V (± 5%)
Output voltage: approx. 200 - 300 V/DC
Ultrasonic frequency: approx. 22 kHz ± 10%
Sound pressure: max. approx. 100 dB ± 20% (ultrasonic devices should have a sound pressure level of over 100 dB (C) to prevent habituation (ADAC test result). (Source: de.wikipedia.org/wiki/Marderabwehr)
Beam angle: Ultrasound approx. 160°
Speaker: Structure-borne sound emitter that causes the top of the housing to vibrate (waterproof)
Sound: sine wave, aggressively pulsating
Temperature range: approx. -25 to +80°C
Function indicator: flashing LED (approx. every 5 - 12 seconds)
Cable length: High-voltage cable approx. 4 m (± 10%)
Fuse: 1 A in fuse holder
High-voltage contact plates: 6 pieces, movable, each approx. 62 x 42 mm, made of stainless steel
Dimensions: Base unit approx. 40 x 50 x 70 mm (without cable entry + mounting feet)
Cable for terminal 15: If this cable is connected to "plus," the marten repellent switches off. If it is connected to "minus" or receives no signal, the marten repellent switches on.
CAN data bus: Suitable for vehicles with CAN data bus
Voltage spikes: The device is protected against voltage spikes in the vehicle electrical system up to 40V (< 20ms).
Visual deterrent: The built-in pulsating LED further unsettles the nocturnal marten.
Why does the device not have a frequency change? Martens and other small predators emit short, loud warning cries, not siren tones! Our marten repellent imitates these sounds very realistically and is therefore the optimal marten deterrent.
Protection class IP65: No dust ingress at a negative pressure of 20 mbar in the housing. Protected against water jets from any direction against the housing (corresponds to 12.5 liters/minute - garden hose) (test time 5 minutes)