Offgridtec© Solar Module Carrier 5W - 30W black
Shipped in 1-3 days
€33.49*
€28.14**
With this solar module support stand, you can screw your module "upright" onto a flat roof or any other surface with the appropriate load-bearing capacity. The basic set consists of a stand with a tiltable support axis. The scope of delivery also includes module adapter strips of various lengths, which can be used to attach the module to the support. The module adapters supplied are suitable for solar modules with a power range of 5-30W. The flexible tilt angle of the bracket allows for optimal alignment of the solar module.
The bracket itself is connected to the ground by four drill holes. Offgridtec supplies dowels and screws for fastening in reinforced concrete as standard. However, the bracket can also be mounted on wooden beams or stone walls using appropriate screws.
A pair of M6 wing nuts with snap rings and washers + matching 16x6 hex nuts for screwing the module to the adapter bar are also included in the scope of delivery.
Installation note: Pleasenote that you may need to drill two holes in the frame of your solar module in order to screw the module to the bracket. This depends entirely on the type of solar module and the factory-made holes. If you need to drill into the frame, we definitely recommend using a depth stop when drilling so as not to damage the back of the solar module.
Scope of delivery:
- - Module stand with tiltable axis for optimal module inclination
- - Module adapter strip 22 cm, 36.5 cm, 41.5 cm
- - Electrogalvanized wing nuts, snap rings, and washers, as well as 4 pcs. 6x16mm nuts for attaching the module to the adapter bar
- - 4 x 6x50mm screws + dowels for fastening in brick walls or reinforced concrete walls
Manufactuerer Information
Offgridtec AG
Offgridtec AG
Im Gewerbepark 11
84307 Eggenfelden
Germany
Mail: info@offgridtec.com
Tel.: +49 8721 9199400