Steca PR 1010 Solar Charge Controller 10A 12V/24V

This two-cored solar cable connects charge controller and solar modules within a system in a professional way.On the module side it is equipped with original Multi-Contact MC4-plugs - the charge controller side with ferrules.Most modules work with MC4-plugs. If not you'll find fitting adaptors in our shop. All components are prepared with professional tools and provide a high connection quality. The cable is manufactured in our factory in Lower Bavaria. Data cable: diameter 4mm double-isolated very flexible VDE 0295 class 5 and IEC 60228 resistant against UV, ozone, weather,water, chemicals, oil fire-resistant according to VDE 0482-332-2, DIN safe from touch protection IP: unplugged - IP2X; plugged - IP67 temperature range: -40° ...60° C isolation material: PA locking-system: snap-in cable strain relief according to IEC 61984 contact system: MC Multilam contact material: tinned copper flame class: UL94-V0 protection class II system voltage up to 1000V Data ferrules: material: tinned copper length: 12mm

This cable is used to connect all common charge controllers to a Schaudt-EBL. Features: length 1m for all common charge controllers Delivery scope:1 x EBL connection cable 1m

With the battery selector Switch by Offgridtec (MPN 012820) you can turn on an off two batteries as well as control them seperately to reduce the power consumption, when the device, vehicle or boat is not in use. The Switch is suitable for automotive electronic, electronic devices and all Kinds of 12V/24V/48V vehicles, boats, camper etc. The practical Rotary Switch is easy to serve and works smoothly. With Switch Position 1 or 2 you can turn on one of the connected batteries, with 1&2 both batteries are connected with the circuit and OFF (red) means turning off both batteries. When the device or vehicle is not in use, you can use the Switch to separate the Connection between the batteries safe and to reduce the energy consumption. Features Suitable for 12V/24V/48V Continuous current 12V DC: 200A Intermittently current 12V DC: 455A Momentary current 12V DC: 1250A Weight: 260g dimensions of selector switch: 69 x 69 x 74mm dimensions for the 4 removable cable glands: 45 x 20mm Guard and locking service The locking System can be used as Independent unit or parallel to other Switches. It can protect the power supply, reduce the battery loss and extend the battery lifespan. More important is that the Switch prevents the leave of electricity and protect your personal security. The switch is not removable. Durable material The selector Switch is manufactured out of CE-certified, high-Quality ABS-flame retardant, reinforced Nylon and bolts made of silver plated red copper. It is humidity-, UV- and aging resistant and disposes a Long lifespan. The back cover is isolated, to prevent short circuits, fulfill security conditions and prohibit electrical accidents. Easy installation The battery selector Switch can be installed easily and fast. You have to keep an eye on the arragement of the positive and negative wires, then you install the corresponding covering lamella and tighten the four screws, to prevent the cable connector from oxidizing.  Scope of delivery: 1x Battery selector swith 4x detachable side plate 1x bottom plate 4x screws 4x nuts