Victron MultiPlus 48/800/9-16 230V

The new MultiPlus 48/800/9-16 (Victron Energy, PMP481800000) is the successor to the Multiplus Compact 48/800. This device is a modern combination of a powerful pure sine wave inverter, an advanced 9A battery charger that uses adaptive charging technology, and a 16A high-speed AC transfer switch.

In the event of a grid failure or if the shore power or on-board generator is interrupted, the Multis inverter switches on automatically and takes over the supply to the connected consumers. The switchover is so fast (in less than 20 milliseconds) that uninterrupted operation of computers and other electronic devices is guaranteed.

key features of the MultiPlus 48/800/9-16

• Continuous output power at 25°C: 700W / 800W with non-linear load
• Victron Energy MPN: PMP481800000
• for 48V system voltage
• integrated 9A mains charger for your batteries
• integrated 16A mains transfer switch
• UPS operation possible
• Extensive accessories available
• Can be used in numerous applications, whether on land or mobile

proven reliability

The complete bridging, supplemented by a ring transformer topology, has proven itself over many years. The inverter is short-circuit-proof and protected against overheating (whether caused by overload or ambient temperature).

PowerControl – (Multiplus 800VA 1200VA only).

The Multi Control remote control panel can be used to set the maximum mains or generator power that can be drawn. The MultiPlus then takes into account other connected AC loads and only uses the power that is "left over" for charging. This prevents the generator or shore power connection from being overloaded.

PowerAssist – (MultiPlus 800VA 1200VA only)

Load peaks often only occur for a limited period of time. In such cases, the MultiPlus ensures that insufficient shore power or generator power is immediately compensated for by energy from the battery. If the load is reduced, i.e., if consumers are switched off, the energy that is then available again can be used to charge the batteries.

High switch-on power

This is required to switch on loads with high inrush currents, such as voltage converters for LED lamps, halogen lamps, or power tools.

Search mode

If search mode is set to 'on', the inverter's power consumption is reduced by approximately 70% during zero load operation. In this mode, when operating in inverter mode, the Multi switches off at zero load or low load and switches back on again for a short period every two seconds. If the output current exceeds a set limit value, the inverter resumes operation. If this is not the case, the inverter switches off again.

programmable relay

In the default setting, the multifunction relay acts as an alarm relay, i.e., it switches off the device in the event of malfunctions (device becomes too hot, hum voltage at the input too high, battery voltage too low).

Scope of delivery

Victron Energy PMP481800000, MultiPlus 48/800/9-16