Offgridtec backup kit 19.2kWh Pylontech LiFePO4 battery - Victron MultiPlus II 48/10000 3-phase inverter

The backup systems from Offgridtec are ideal for emergency power supply or for expanding an existing solar system. In addition to lithium-ion batteries from Pylontech, the systems include a suitable MultiPlus-II inverter and a Cerbo GX for system monitoring from Victron Energy. This allows you to secure your energy supply even in the event of a power failure. Thanks to the UPS function, the MultiPlus remains switched on even in the event of a mains failure and takes over the supply to the connected loads. The switchover happens so quickly (in less than 20 milliseconds) that uninterrupted operation of computers and other electronic devices can be guaranteed. Areas of application for the Offgridtec backup kit: Emergency power supply Off-grid solar systems (stand-alone systems) Retrofitting existing PV systems Grid-connected power supply UPS systems What does the Offgridtec backup system contain? Pylontech US5000 4.8kWh LiFePO4 battery (4x or 6x depending on selection) 3x Victron MultiPlus-II 48/10000/140-100 230V device combination 2x Victron Lynx Distributor 1x Victron Lynx Power In 1x Victron Cerbo GX control panel 1x Victron GX Touch 50 display panel for Cerbo GX 1x 1.8m VE.Can to Can-Bus BMS type A cable 1x 3m Victron RJ45 UTP Cable 2x 0,9m Victron RJ45 UTP Cable 6x 1m Offgridtec battery cable 50mm² M8 eyelets 4x Pylontech battery connection cable set 2x Offgridtec set of 5 MEGA fuses 200A The Multiplus device combination is preconfigured to suit the Pylontech batteries. Extended use of your backup system An energy meter with connection cable is required to set up an ESS (Energy Storage System) with the backup system: Victron VM-3P75CT Energy Meter 3-phase electricity meter 75A/phase 5m Victron RJ45 UTP Cable With this electricity meter, you can carry out a grid-parallel installation and then monitor your energy consumption and control your energy costs. Thanks to phase compensation, you can also operate the 3-phase meter for single-phase systems. This means that seamless integration of decentralised energy sources and consumers into the existing power grid is no problem. In order for an ESS to be taken into account in the pre-configuration, the meter must be purchased in advance or for the system! The storage solution - Pylontech US5000 batteries The Pylontech US5000 storage system is a lithium battery of the latest generation. It was specially developed to fulfil the high demands placed on backup storage systems. Thanks to state-of-the-art technology, maximum safety and a long service life are guaranteed even with regular deep discharges. Extremely cycle-resistant - over 6000 cycles at 95% DoD Absolutely intrinsically safe lithium technology High charging and discharging capacity possible Integrated BMS Very high storage density - low weight and compact design Absolutely maintenance-free and durable Pre-charging function to protect the ESS system from overvoltage function The electronic core - the Victron Multiplus-II device combination The Multiplus-II is a high-end device combination from Victron Energy, consisting of a 48V battery charger, inverter and transfer switch. This combination combines the classic Multiplus components with an external current sensor and integrated anti-islanding function. This expands the PowerControl and PowerAssist functions to 50A and extends the potential range of use to energy storage system applications. The Multiplus is therefore ideal for use as a backup device in grid-connected and off-grid power supply systems. 10000W power with non-linear load - 8000W continuous load - 18000W peak power for 48V battery voltage 100A transfer switch 140A battery charger Output voltage: 230 VAC, frequency: 50 Hz Max. efficiency: 95 Protection class: IP22 System monitoring with the Victron Cerbo GX and GX Toch display With the Cerbo GX communication centre, you can easily control and monitor your system. The flexible connection options maximise your system performance. Thanks to the Cerbo GX, you can control your system from anywhere. With the GX Touch 50 display, you always have an overview of all your system parameters and can make changes quickly and easily.

The backup systems from Offgridtec are ideal for emergency power supply or for expanding an existing solar system. In addition to lithium-ion batteries from Pylontech, the systems include a matching MultiPlus-II inverter and a Cerbo gx from Victron Energy for system monitoring. This allows you to secure your energy supply even if there is a power failure. Thanks to the UPS function, the MultiPlus remains switched on even in the event of a mains failure and takes over the supply of the connected loads. The switchover happens so quickly (in less than 20 milliseconds) that uninterrupted operation of computers and other electronic devices can be guaranteed. Areas of application of the Offgridtec backup kit: Emergency power supply Off-grid solar systems (stand-alone systems) Retrofitting of existing PV systems Grid-connected power supply UPS systems What does the Offgridtec backup system contain? Pylontech us2000c 2.4kWh LiFePO4 battery (2x or 4x depending on selection) 1x Victron MultiPlus-II 48/3000/35-32 230v device combination 1x Victron Lynx Distributor 1x Victron Cerbo gx control panel 1x Victron gx Touch 50 display panel for Cerbo gx 1x 1,8m VE.Can to Can-Bus bms type A cable 1x 3m Victron rj45 utp cable 1x 1m Offgridtec battery cable 50mm² M8 eyelets 1x 125a 70v mega fuse 1x Pylontech battery connection cable set The Multiplus device combination is pre-configured to fit the Pylontech batteries. Extended use of your backup system To establish an ESS (Energy Storage System) with the backup system, an energy meter with connection cable is required for each: • Victron VM-3P75CT Energy Meter 3-phase electricity meter 75A/phase • 5m Victron RJ45 UTP Cable With this electricity meter, you can perform a grid-parallel installation and then monitor your energy consumption or control your energy costs. Thanks to phase compensation, you can also operate the 3-phase meter for 1-phase systems. This enables seamless integration of decentralized energy sources and consumers into the existing power grid. To ensure that an ESS can be considered in the pre-configuration, the meter must be purchased in advance or as part of the system! The storage solution - Pylontech us2000c batteries The us2000c storage is a lithium battery of the latest generation. It has been specially designed to meet the high demands placed on backup storage. Thanks to state-of-the-art technology, the highest level of safety and a long service life are guaranteed, even with regular deep discharge. Extremely cycle resistant - over 6000 cycles at 95% DoD Absolutely intrinsically safe lithium technology High charge and discharge capacity possible Integrated bms Very high storage density - low weight and compact design Absolutely maintenance-free and durable Pre-charge function to protect the ESS system from overvoltage function The electronics core - the Victron Multiplus-II device combination The Multiplus-II is a high-end device combination from Victron Energy, consisting of 48v battery charger, inverter and transfer switch. This combination combines the classic Multiplus components with an external current sensor and integrated anti-islanding function. This extends the PowerControl and PowerAssist functions to 50a and extends the potential range of use to energy storage system applications. The Multiplus can therefore be ideally used as a backup device in grid-connected and grid-independent power supply systems. 3000W non-linear load power - 2400w continuous load - 6000w peak power for 48v battery voltage 32A transfer switch 35A battery charger Output voltage: 230 vac, frequency: 50 Hz max. efficiency: 95% Protection class: IP22 System monitoring with the Victron Cerbo gx and gx Toch display Easily control and monitor your system with the Cerbo gx communication center. The flexible connectivity options maximize your system performance. Control of your system is possible regardless of location thanks to the Cerbo gx. With the gx Touch 50 display, you always have all the parameters of your system in view and can make changes easily and quickly.